![]() ![]() When you turn the board upside down, the water will flow away from the glue rather than sinking deeper into it. Dry your skateboardĪllow your skateboard to dry by placing it upside down on a rack or between two items (such as chairs). Your traction should be OK as long as you remove the caked-on dirt from the grip. Your skateboard’s performance will not be harmed by a little surface debris. If you don’t care about the appearance of your board and simply worry about how it skates, you may skip this stage and save yourself some water. Making a last run over the deck will ensure that your griptape is clean all the way around. If you don’t do this, your griptape will have some really clean patches that will make the rest seem dingy. Dip your brush in water, flick off the excess, and then brush your whole board after you’ve gotten all the nasty areas off of your griptape. Only do this if your skateboard’s appearance is important to you. Water should not be left on your grip tape. Repeat the process with the next filthy place on the boardĬleaning griptape should be done one location at a time, with each patch drying in between. If you rub the towel against the griptape, it will get clogged with towel fuzz. Using a cloth, wipe the water away from the board ![]() To prevent harming the surface, don’t scrape too hard. Scrub the dirt up with a soft brush until it comes up. Using the damp brush, clean a filthy place A little quantity of water will have little effect. To clean your skateboard griptape, make sure your brush is just damp. Scrubing with the brush, particularly if it’s a wire brush, is not a good idea. You’re just loosening and brushing away compacted dirt. Brush very softly over the top of the griptape while brushing. Remove some of the additional filth from your skate deck before beginning with the water. Remove any extra dirt from the deck using a brush A little water will go a long way toward restoring the lustre of your skateboard’s grip. However, you’ll need some water, and water isn’t good for your griptape or the deck of your skateboard. When the surface is totally dry, spread grip gum over it to remove any remaining particles. Wipe away the debris with the paper towel after gently rubbing the filthy area with the brush. You just want to moisten the surface of your grip, not saturate your board, so don’t go too crazy with the water. A gentle brass brush OR a firm bristled toothbrush.This brush approach takes a little more muscle and is perfect for removing crusty muck. To remove dirt from your grip tape, just rub the grip gum along the dirty spots. Dust, small grime, and even gum are best removed using grip gum. When it comes to skateboard grip tape, how frequently should you change it?Ĭleaning grip tape using grip gum is the most common and simple method.Is it necessary to use grip tape on a skateboard?.Repeat the process with the next filthy place on the board If you're looking for spots or people to skate with in your area ( click here to browse through posts tagged looking for spots/skaters) Use the discussion thread or /r/kookboarder if you must share prohibited content listed above. Flair descriptions can be found in the link above.If you don't provide source or skater's name Submit any and all questions to the discussion thread discussion threadģ.No snowboarding, snow skating, trampoline skating, ripstick, scooter, longboarding, etc. Your post must contain videos and/or pictures of skateboarding Discord for r/Skateboarding here Submission Rules: 1. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |